EL wire 4xAAA pocket inverter

EL wire 4xAAA pocket inverter

More details

Price and order

ADA-00564

12,00 € incl. tax

1 item in stock

Quantity from 1 to 4 from 5 to 9 from 10 to 24 from 25 to 49 from 50 to +
Price 12,00 € 11,76 € 11,40 € 11,16 € 10,80 €

A small, portable inverter for EL wire. Powers off of 4 AAA batteries (not included!), it can drive 3-4 meters (10 to 13 feet) of our high-brightness EL wire OR 1 meter (3 feet) of EL tape OR a 10cmx10cm piece of EL panel for about 7 hours.

 

There is a switch for selecting steady/blink/off modes. Comes with four 2.5mm pitch female JST connectors, standard for all the EL wire and tape we carry. The JST cables snap into the inverter, so if you don't need all 4 cables, you can use as few as you want. The inverter does not 'sequence' the 4 cables, so if you use 'blink mode' all the strands will blink at the same time.

 

There is a 1.7mm DC jack on the side so you can put in 5-6VDC to power this off of a different battery or power source, This cable has a matching DC plug on the end)

 

You can plug any of our EL wire/tape into this inverter directly. To connect a 'raw' piece EL wire to this, you'll want a male connector wire

 

The EL inverter requires a 'load' to stabilize itself. Do not run the inverter without at least 2 ft of EL wire attached! Otherwise the inverter can spike and damage itself

 

Like all inverters we've used, the 2000 Hz oscillation is slightly audible. To reduce the squeaking, we suggest opening up the case padding it with thick foam tape/weatherstripping. Squirting some hot glue around the capacitors may also help. We managed to get it silent this way.

 

Dimensions:

Inverter Size: 85mm x 55mm x 22mm (3.4in x 2.2in x 0.85in)

JST cable length: approx. 20 cm

Weight (without batteries): 60g

 

Batteries non included.

 

Visit official webpage for more informations.

 

Like all our products, this kit is RoHS.

Logo RoHS

No customer comments for the moment.

Only registered users can post a new comment.