Adafruit NeoPixel Digital RGB LED Strip - White 60 LED - Roll 1m

Adafruit NeoPixel Digital RGB LED Strip - White 60 LED - Roll 4m

More details

Price and order

ADA-01138Roll

132,00 € incl. tax

1 item in stock

Quantity from 1 to 4 from 5 to 9 from 10 to 19 from 20 to +
Price 132,00 € 129,36 € 125,40 € 121,44 €

The 4m strip is made of flexible White PCB material, and comes with a weatherproof sheathing. You can cut this stuff pretty easily with wire cutters, there are cut-lines every 0.65"/1.7cm (1 LED each). Solder to the 0.1" copper pads and you're good to go. Of course, you can also connect strips together to make them longer, just watch how much current you need! We have a 5V/2A supply that should be able to drive 1 meter (depending on use) and a 5V/10A supply that can drive up to 4 meters (depending on use) You must use a 5V DC power supply to power these strips, do not use higher than 6V or you can destroy the entire strip.

 

There is a single data line with a very timing-specific protocol. Since the protocol is very sensitive to timing, it requires a real-time microconroller such as an AVR, Arduino, PIC, mbed, etc. It cannot be used with a Linux-based microcomputer or interpreted microcontroller such as the netduino or Basic Stamp. Adafruit wonderfully-written Neopixel library for Arduino supports these pixels! As it requires hand-tuned assembly it is only for AVR cores but others may have ported this chip driver code so please google around. An 8MHz or faster processor is required. 

 

One 4m roll (full roll) with connector and a weatherproof sheathing.

 

  • 12.5mm (0.65") wide, 4mm (0.16") thick with casing on, 16.7mm (0.65") long per segment
  • 60 LEDs per meter
  • Removable IP65 weatherproof casing
  • Maximum 5V @ 60mA draw per 0.65" strip segment (all LEDs on full brightness)
  • 5VDC power requirement (do not exceed 6VDC) - no polarity protection
  • 1 integrated RGB LEDs per segment, individually controllable
  • LED wavelengths: 630nm/530nm/475nm
  • Connector: 2-pin JST SM

 

 

 

  • Dimensions: 12.5 mm x 4 mm x 1m, 16.7 mm each segment.

 

You must use a 5V DC power supply to power these strips, do not use higher than 6V or you can destroy the entire strip. Mind the polarity !

 

Visit official webpage for more informations.

 

Like all our products, this kit is RoHS.

Logo RoHS

No customer comments for the moment.

Only registered users can post a new comment.