Console cable for Raspberry-pi USB to TTL

USB to TTL Serial Cable - Debug / Console Cable for Raspberry Pi

More details

Price and order


11,94 € incl. tax

42 items in stock

Quantity from 1 to 4 from 5 to 9 from 10 to 19 from 20 to +
Price 11,94 € 11,70 € 11,34 € 10,98 €

The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX out of the USB port. The power pin provides the 5V @ 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets.


Because of the separated pin plugs, this cable is ideal for powering and connecting up to the debug/login console on the Raspberry Pi. Connect the pins as shown to power the Pi and establish the RX/TX link. Then install the Windows XP/Vista/7 or MacOS X PL2303HX.A drivers on your computer and connect with a terminal program at 115200 baud. Windows 8 is not supported.


Also handy for hacking WiFi routers to install alternate OS's, or nearly any other TTL port. This is easier to use than an FTDI cable in many cases because the wires are separated


This cable is not good for Arduino re-programming such as a Boarduino, MENTA, Monochron, etc. because it does not have the DTR/RTS wire necessary for initiating the bootloader reboot sequence. For that we suggest an FTDI cable or FTDI friend.


More information on Adafruit website


Like all our products, this kit is RoHS.

Logo RoHS

From Comment
2014-03-01 Guillaume .... Installation et utilisation ok sous Windows 7 en suivant le tuto Adafruit (
Attention : Le câble que j'ai reçu est basé sur un PL-2303 XA / HXA non compatible avec Windows 8/8.1 comme indiqué par l'éditeur du driver :

Only registered users can post a new comment.