DHT11 temperature-humidity sensor

DHT11 temperature-humidity sensor + extra

More details

Price and order

ADA-00010

5,50 € incl. tax

27 items in stock

The DHT11 is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2 seconds, so when using our library, sensor readings can be up to 2 seconds old.
We have written an Arduino library with example code

Compared to the DHT22 (the one inside the AM2302 that we sell here as well) this sensor is less precise, less accurate and works in a smaller range of temperature/humidity, but its smaller and less expensive

Comes with a 4.7K or 10K resistor, which you will want to use as a pullup from the data pin to VCC.

 

Technical Specs :

Low cost

3 to 5V power and I/O

2.5mA max current use during conversion (while requesting data)

Good for 20-80% humidity readings with 5% accuracy

Good for 0-50°C temperature readings ±2°C accuracy

No more than 1 Hz sampling rate (once every second)

Body size 15.5mm x 12mm x 5.5mm

4 pins with 0.1" spacing

 

 

No customer comments for the moment.

Only registered users can post a new comment.